billy10 Posted September 30, 2010 Share Posted September 30, 2010 Hi Forum,Got a problem with satellite reception, I have a digi Sky box , a 80 cm dish on roof and I get perfect reception of all freesat programmes,Recently I bought another dish ( 100 cm) and a universal lmb to use with my campervan,so I got the sky box connected it up to the new dish ( which is on a tripod on the patio) switched on the tv and sure enough after I had roughly aligned it with a meter the setup screen said I had a signal both bars were about 75 percent, however I cannot get any channels as sometimes it says no default transponder and other times it says no signal being received although the setup screen shows a signal, also I notice that there is no network id (000)and also no transport stream ??? What am I doing wrong !! Any help would be greatly appreciated.Regards Billy10[ Link to comment Share on other sites More sharing options...
Théière Posted October 1, 2010 Share Posted October 1, 2010 At a guess, the wrong satellite [:$] Link to comment Share on other sites More sharing options...
Dog Posted October 1, 2010 Share Posted October 1, 2010 If the satelite is pointed in the correct direction it's gotta be something else.If the 'lmb' is that thingy that points at the dish makes sure it's got a low number on it and that it works.The lower the number the more powerful and less interference.They do get water inside and sometimes just give up and die. Link to comment Share on other sites More sharing options...
Pierre ZFP Posted October 1, 2010 Share Posted October 1, 2010 Assuming as above that its pointing at the right place, the LNB may have to be skewed to receive the proper signal. By skewed I mean turing it 45 deg (I think) I don't know the exact number of degrees as my LNB has a arrow maked on it just for this.The next step is to do a full satellite and chanal scan and see what you get. Link to comment Share on other sites More sharing options...
Théière Posted October 1, 2010 Share Posted October 1, 2010 Assuming it's the wrong satellite which is why you can't get a network id (0002 for Astra 2) and also no transport stream.Why does it take OP's so long to come back? Link to comment Share on other sites More sharing options...
Anton Redman II Posted October 2, 2010 Share Posted October 2, 2010 If I had somewhere with a dish already set up I would align the second dish by eye rather than with a satfinder.Try unplugging the digibox counting to ten and reconnecting they sometimes lock up and fail to display subsequent changes in signal strength/quality. You should be able to get well beyound 75% strength with 100 cms andwhere in mainland France. Bigger dishers are harder to align. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.