Payrac-man Posted September 11, 2007 Share Posted September 11, 2007 Hi AllCan anyone help? I have had a new Delta Dore GP500 driver 520 installed and I cannot programme it. I have the installation book but cannot work out how to set the délestage to 9kw so as not to trip the disjoncteur. Has any one else seen one of these? My french is not up to this Sadly!!Thanks Paul Link to comment Share on other sites More sharing options...
Nick Trollope Posted September 12, 2007 Share Posted September 12, 2007 The deselecteur setting is on the controller (fitted to the tableau), I think you are looking at the programmer.Yes? If not, I'll look a bit deeper. Link to comment Share on other sites More sharing options...
Payrac-man Posted September 12, 2007 Author Share Posted September 12, 2007 Hi NickThanks for replying, I cannot see anything that looks like a setting on the GP500 unit in the cabinet. The programmer has an error message saying that it is not communicating with the meter but which wires do I connect on the meter as I have a choice of 6 terminals and I only have 2 wires. There are settings in the programmer to alter the price per KWH so it works out the cost for you but I can't work out to set the deselecteur setting. www.delta-dore.com/bdd/Notice_Utilisation/web_PackLabel_PRE_util_rev2.pdf -http://www.delta-dore.com/bdd/Notice_Installation/web_PackLabel_PRE_instal_rev2.pdfThese are the instructions any help is appreciatedPaul Link to comment Share on other sites More sharing options...
Nick Trollope Posted September 12, 2007 Share Posted September 12, 2007 I can't remember exactly , but it is the bottom RH pair of terminals on the meter, I believe.This pair of wires gives current consumption information to the management unit.However, I wouldn't connect these up based on this information until I had checked it out. Link to comment Share on other sites More sharing options...
Payrac-man Posted September 13, 2007 Author Share Posted September 13, 2007 Thanks NickAny ideas where to find out that info for sure? All the best Paul Link to comment Share on other sites More sharing options...
Nick Trollope Posted September 13, 2007 Share Posted September 13, 2007 Yup. It appears that the "teleinfo" input/output is connectio I1/I2 in the bottom RH corner (of the L&G meters used around here). Link to comment Share on other sites More sharing options...
Payrac-man Posted September 14, 2007 Author Share Posted September 14, 2007 Hi NickThanks again I'm down in the house in 2 weeks time so I'll connect it up and fingers crossedAll the best Paul Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.