chirpy Posted June 9, 2009 Share Posted June 9, 2009 Hi,What is the requirement for ceiling light -.is a glass covered unit necessary over the 100watt bulb.? Link to comment Share on other sites More sharing options...
Théière Posted June 9, 2009 Share Posted June 9, 2009 Using an I.P. rated light fitting for any outside requirements should be the correct route to prevent water ingress and the possibility of fire and in order to meet the I.P. rating the lamp would be enclosed to prevent bursting of the lamp should water come into contact with the lamp. Link to comment Share on other sites More sharing options...
chirpy Posted June 10, 2009 Author Share Posted June 10, 2009 thanks,What does I.P. stand for?The light would be inside a tiled roof storeroom where the oil tank is surrounded by concrete bund area in case of any problems. Link to comment Share on other sites More sharing options...
Pierre ZFP Posted June 10, 2009 Share Posted June 10, 2009 I.P. rating is the Internal Protection rating (aka Ingress Protection Rating)http://en.wikipedia.org/wiki/IP_CodeI only know this as recently I was looking for an external light and saw these ratings and wondered what they were.BTW, am I right in thinking you won't be able to get 100 watt lightbulbs for much longer and they will have to be the equivalent low energy thingies? Link to comment Share on other sites More sharing options...
andyh4 Posted June 10, 2009 Share Posted June 10, 2009 [quote user="Pierre ZFP"]BTW, am I right in thinking you won't be able to get 100 watt lightbulbs for much longer and they will have to be the equivalent low energy thingies?[/quote] From what I have read absolutely right, and it seems that some stores have already stopped stocking 100W incandescent bulbs even though the new requirements don't come into force until September (and I am not sure whether at that point it is 100W bulbs that are banned from sale or >100W). Link to comment Share on other sites More sharing options...
BIG MAC Posted June 10, 2009 Share Posted June 10, 2009 Where there is a potential for a volatile gas being present then the fitting and switching should both be 'Intrinsically safe' ie any starter or contactors should be appropriately shielded.I have no idea what the French Regs will say however things can go bang! or Le bang! doesn't make much odds when the roof is in the car park.There are other things that may be of interest ie. hard wired smoke / heat detection which can connect to a drop out valve (Isolates fuel supply in the event of alarm being triggered)Tank overfill alarms which will give an audible alert if tank is getting too full and in UK will stop the delivery of fuel when activated if the fuel suppliers equipment is compatible Some equipment will allow you to monitor fuel level from the comfort of your home rather than messing about outside.Hope this helps Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.