Théière Posted January 21, 2014 Share Posted January 21, 2014 [quote user="Mikew"]Don't talk about gaskets to me! Our pellet stove had it's yearly check etc early December. We smelt smoke shortly after - it took two visits to discover that one of the flue gaskets had been split. So far - it is still on order...importer out of stock... time of year ...etc !!!![/quote]Order some gasket material and make your own, not rocket science more Blue Peter. Link to comment Share on other sites More sharing options...
Mikew Posted January 21, 2014 Share Posted January 21, 2014 They are specially shaped ( like a < ) circular silicon and are used where one pipe slides into another. Heat and CO make a proper replacement necessary! Link to comment Share on other sites More sharing options...
Théière Posted January 21, 2014 Share Posted January 21, 2014 Aha. Link to comment Share on other sites More sharing options...
johnnyboy Posted February 12, 2014 Author Share Posted February 12, 2014 T,You asked for some figures a while back, sorry for delay as we've been back in England for a few days.There is actually sun today and system appears to be working, so here goes.Collector Panel temp: 40 deg CPanel Flow temp: 36 deg C Panel Return temp: 23 deg CPump Speed: 100%OAT shade: +4 deg COAT sunlight: +8 deg CCylinder Mid temp: 41 deg CTime: 11:30Panel Flow temp is from the gauge just before entry to hot water tank at bottom and Cylinder Mid temp is from sensor in the hot water tank itself.Will try to get more figures later, pending the weather of course!Johnnyboy. Link to comment Share on other sites More sharing options...
johnnyboy Posted February 17, 2014 Author Share Posted February 17, 2014 More figures for anyone interested!Collector Panel temp: 64 deg CPanel Flow temp: 56 deg C Panel Return temp: 39 deg CPump Speed: 100%OAT shade: +10.7 deg COAT sunlight: +14 deg CCylinder Mid temp: 56 deg CTime: 15:00At least we seem to be getting some benefit now the sun is finally out to play!!J. Link to comment Share on other sites More sharing options...
Théière Posted February 17, 2014 Share Posted February 17, 2014 Thanks Johnnyboy, good to know, what is the outside temp where you are?Your panel return temp seems quite high, could you reduce that and get more heating out into the room/water? Maybe slowing the pump down a little? Link to comment Share on other sites More sharing options...
johnnyboy Posted February 17, 2014 Author Share Posted February 17, 2014 Sorry T, OAT is outside air temp, just an aviation term that I've used!As for control of the pump speed, thats automatic through the heating system controller. I do have a sort of control by selecting permanently on or off or just leaving it on automatic, but thats all. The system is supposed to work that all out for itself, not sure if there is any way I can get a seperate speed control installed.J. Link to comment Share on other sites More sharing options...
Théière Posted February 17, 2014 Share Posted February 17, 2014 Thanks johnnyboy and for OAT. Hmm what sort of pump is it?It maybe more complex than I think as slowing the pump may of course overheat the panel so maybe a slightly bigger heat exchanger is a better option? If a higher tank temperature is needed then maybe not Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.